Case C: Set up the HP All-in-One with a PBX phone system or an ISDN line
If you are using either a PBX phone system or an ISDN converter/terminal adapter,
make sure you do the following:
●
If you are using either a PBX or an ISDN converter/terminal adaptor, connect the
HP All-in-One to the port that is designated for fax and phone use. Also, make
sure that the terminal adapter is set to the correct switch type for your country/
region, if possible.
Note
Some ISDN systems allow you to configure the ports for specific
phone equipment. For example, you might have assigned one port for
telephone and Group 3 fax and another port for multiple purposes. If you
have problems when connected to the fax/phone port of your ISDN
Chapter 3
40
HP Officejet 6300 All-in-One series
Finish
setup
converter, try using the port designated for multiple purposes; it might be
labeled "multi-combi" or something similar.
●
If you are using a PBX phone system, set the call waiting tone to "off".
Note
Many digital PBX systems include a call-waiting tone that is set to
"on" by default. The call waiting tone will interfere with any fax
transmission, and you will not be able to send or receive faxes with the
HP All-in-One. Refer to the documentation that came with your PBX
phone system for instructions on how to turn off the call-waiting tone.
●
If you are using a PBX phone system, dial the number for an outside line before
dialing the fax number.
●
Make sure you use the supplied cord to connect from the telephone wall jack to
the HP All-in-One. If you do not, you might not be able to fax successfully. This
special phone cord is different from the phone cords you might already have in
your home or office. If the supplied phone cord is too short, you can purchase a
coupler from your local electronics store and extend it.