Test your fax setup
You can test your fax setup to check the status of the HP All-in-One and to make sure
it is set up properly for faxing. Perform this test after you have completed setting up
the HP All-in-One for faxing. The test does the following:
●
Tests the fax hardware
●
Verifies the correct type of phone cord is connected to the HP All-in-One
●
Checks that the phone cord is plugged into the correct port
●
Checks for a dial tone
●
Checks for an active phone line
●
Tests the status of your phone line connection
The HP All-in-One prints a report with the results of the test. If the test fails, review the
report for information on how to fix the problem and rerun the test.
To test your fax setup from the control panel
1.
Set up the HP All-in-One for faxing according to your particular home or office
setup instructions.
2.
Insert the print cartridges and load full-size paper in the input tray before starting
the test.
User Guide
55
Finish
setup
3.
Press
Setup
.
4.
Press
6
, then press
6
again.
This selects the
Tools
menu and then selects
Run Fax Test
.
The HP All-in-One displays the status of the test on the display and prints a report.
5.
Review the report.
–
If the test passes and you are still having problems faxing, check the fax
settings listed in the report to verify the settings are correct. A blank or
incorrect fax setting can cause problems faxing.
–
If the test fails, review the report for more information on how to fix any
problems found.
6.
After you pick up the fax report from the HP All-in-One, press
OK
.
If necessary, resolve any problems found and rerun the test.